USB-C 3.1 cables are considered full-featured USB-C cables. They are electronically marked cables that contain a chip with an ID function based on the configuration channel and vendor-defined messages (VDM) from theUSB Power Delivery 2.0specification. Cable length should be ≤ 2 m for gen. 1 or ≤ 1 m for gen. 2.Electronic ID chip provides information about product/vendor, cable connectors, USB signalling protocol (2.0, gen. 1, gen. 2), passive/active construction, use of VCONNpower, available VBUScurrent, latency, RX/TX directionality, SOP controller mode, and hardware/firmware version.
USB-C 2.0 cables do not have shielded SuperSpeed pairs, sideband use pins, or additional wires for power lines. Increased cable lengths up to 4 m are possible.
All USB-C cables must be able to carry a minimum of 3 A current (up to 60 W @20V) but can also carry high-power 5 A current (up to 100 W). All USB-C to USB-C cables must contain e-marker chips programmed to identify the cable and its current capabilities. USB Charging ports should also be clearly marked with capable power wattage.
Full-featured USB-C cables that implementUSB 3.1gen. 2 can handle up to 10 Gbit/s data rate at full duplex. They have been marked with a SuperSpeed+ (SuperSpeed 10 Gbit/s) logo. There are also cables which can carry onlyUSB 2.0with up to 480 Mbit/s data rate. There areUSB-IFcertification programs available for USB-C products and end users are recommended to use USB-IF certified cables.
Sorry, there are no products matching your search.